Interactive 3D
Walk through a complete compressor room.
Compressors, dryers, filters, receivers, nitrogen and heat recovery, laid out the way a well designed utility room should be, then the shop floor that uses the air. Tap any station to see how it works, what it costs to run and what to buy.
Opens full screen. Works on a phone: use the joystick to walk and tap any station. Prefer to read? Every station is listed below.
Every station in the room
The same stations you can walk in 3D, with the equipment and the sizing tool for each.
What does your air cost?
A year of power often costs more than the compressor. Price your own air.
See the equipment →Inside the air end
Screw rotors trap air, shrink it and push it out hot.
See the equipment →Four ways to make less air
Load and unload, modulation, variable capacity and variable speed.
See the equipment →One brain, one pressure band
A master controller keeps every machine visible and the pressure steady.
See the equipment →Where the water goes
Hot air cools in the receiver and drops its water.
See the equipment →Cool it, catch it, drain it
A refrigerated dryer brings air to about 38 °F pressure dew point.
See the equipment →Choose your class
Every psi of filter drop costs about 0.5% of compressor power.
See the equipment →Drain water, not air
Zero-loss drains and an oil-water separator.
See the equipment →Storage buys time
Size receivers for the peak, not the average.
See the equipment →Pipe race
Same air, different pipe: watch the pressure drop.
See the equipment →Half the air never does work
Leaks run about 20% of demand in most plants.
See the equipment →Make your own nitrogen
PSA and membrane generators sized against your cylinder or bulk bills.
See the equipment →Heat you already paid for
Most of a compressor's power comes out as heat you can reuse.
See the equipment →Vacuum
Claw, vane, liquid ring, dry screw, rotary piston and booster systems.
See the equipment →Power
Isolation and drive isolation transformers sized from motor horsepower.
See the equipment →Want this room in your plant?
Send the demand, the pressure and the hours. We will size the room and send a quote.
- Questions about an online ordersupport@prpreps.ca
- Sales and quotessales@prpreps.ca
- Phone+1 647 717 6264
How we take the risk out of a project
A big purchase from a specialist supplier should feel safer than one from a catalogue, not riskier. This is how every equipment order is handled.
Size, voltage and site fit are checked by our engineering team on every equipment order. If something does not fit, we call you before anything ships.
Scope, who does what, schedule, start-up and the acceptance test are agreed in writing before you issue the purchase order. No surprises at commissioning.
Rigging, piping, electrical connection and start-up are done by licensed service partners in Ontario, with one point of contact: us.
For energy projects we can log power, pressure and flow before and after, so the savings are measured against your own baseline. How an audit works.
Every product carries the manufacturer's standard warranty, stated in writing with the order.
Orders over $10,000 are paid on invoice, never up front by card. Never send money to new banking details received by email. Payment safety.